Attwood Tsunami RECIRQ Aerator Kit Bedienungsanleitung Seite 1

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Hardware Attwood Tsunami RECIRQ Aerator Kit herunter. Attwood Tsunami RECIRQ Aerator Kit Manuel d'utilisation Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 4
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
T500 Recirq Livewell
Aerator Kit
4253
Installation Instructions
SAVE THESE INSTRUCTIONS
Form Number 69418 Rev. A 06-01
3
®
FEATURES
The T500 Recirq Livewell Aerator Kit is recommended for fishing
boats with built-in livewells that are not equipped with a thru-hull
recirculation system. The pump is sealed and can occasionally be
submerged; however, the electrical wires must never be submerged.
Kit Pump Flow Amp DC Outlet
Part No. Model Gal/Hr Fuse Voltage Hose I.D.
4253 T500 500 3 13.6 3/4" (19mm)
WARNING
Failure to heed the following warnings could cause your boat to
sink or result in explosions, fires, and serious personal injury:
DO NOT use aerator kit to remove gasoline, oil or other
flammable liquids.
Always disconnect the power source when installing or servicing
any electrical product. Remove vessel from water when using any
110/120 volt AC power tools.
Use the correct fuse amperage rating specified for your model
pump. Test circuit breaker protection as installed. Failure to do
so could result in serious personal injury or fire hazard.
Do not use bilge pump hose, or any other type of unreinforced
hose that could leak, split, or puncture.
REQUIRED FOR INSTALLATION
In-line fuse holder with 3-ampere fuse
Waterproof wire butt-connectors for #16 AWG wire
Drill with 1-1/16" (27mm) or 1-1/8" (30mm) hole saw
Phillips head screwdriver
Brown and black lengths of #16 AWG insulated wire
Polyurethane marine sealant for pump mounting threads
Dash-mounted two-way switch (Attwood Part No. 7615)
Wrench for 1-1/4" and 1-1/2" nut
23" length of hose is provided; if longer length is needed, use 3/4"
(19mm) inner diameter, smooth bore, reinforced hose.
CHOOSE MOUNTING LOCATION FOR PUMP AND AERATOR HEAD
For Shallow Tanks
For tanks with less than 8" (20cm) water height between the aerator
head and pump intake:
Offset the mounting locations so the aerator head does not force air
into the pump intake causing cavitation.
For example, mount aerator head at the left side and the pump at
right side of the tank. (Figure 1)
For Deeper Tanks
For tanks with more than 8" (20cm) water height between the aerator
head and pump intake:
Mount the aerator head and pump intake on the centerline of the livewell.
This centerline location ensures the most even distribution of water
flow. (Figure 2)
INSTALL AERATOR PUMP
1. Position aerator pump at least 2" (51mm) from bottom of tank. Maintain
enough clearance for mounting flange and retaining nut. (Figure 3)
2. At chosen pump location, drill a hole of 1-1/16" (27mm) minimum
diameter, but no larger than 1-1/8" (30mm) diameter, through tank.
3. Apply a bead of marine sealant around mounting flange. Insert
pump through mounting hole in tank. Install and tighten retaining
nut finger-tight, then an additional 1/2 to 3/4 turn.
4. Install and tighten stainless steel mesh strainer finger-tight.
INSTALL AERATOR SPRAY HEAD
1. Position aerator spray head 2" (51mm) down from top of tank.
Maintain enough clearance for mounting flange and retaining nut.
(Figure 3)
2. At chosen aerator location, drill a hole of 1-1/16" (27mm) minimum
diameter, but no larger than 1-1/8" (30mm) diameter, through tank.
Figure 2
Aerator Head
Aerator Pump (Intake)
Recirculated Water
T-500
8" (20cm)
or More
Figure 1
Aerator Head
10" Min. Distance
Aerator Pump (Intake)
Recirculated Water
If Less Than
8" (20cm)
T-500
Figure 3
Aerator Head
Aerator Pump (Intake)
Hole Diameter:
1-1/16" (27mm) Min.,
1-1/8" (30mm) Max.
Recirculated Water
3/4" (19mm) ID
Smooth-Bore
Reinforced Hose
Seitenansicht 0
1 2 3 4

Inhaltsverzeichnis

Seite 1 - Aerator Kit

T500 Recirq LivewellAerator Kit4253Installation InstructionsSAVE THESE INSTRUCTIONSForm Number 69418 Rev. A 06-013®FEATURESThe T500 Recirq Livewell A

Seite 2 - Unlock Lock

©2006 Attwood Corporation1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.com3. Apply a bead of marine sealant around mounting flange

Seite 3 - Trousse d’aérateur

Tête de l’aérateurPompe d’aérateur (Admission)Eau recirculéeT-50020cm (8 po)ou plusTête de l’aérateur25cm (10 po) distance minimumPompe d’aérateur (Ad

Seite 4 - AVERTISSEMENT

©2006 Attwood Corporation1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.comFigure 3INSTALLEZ LE BOYAU1. Insérez le raccord cannelé

Kommentare zu diesen Handbüchern

Keine Kommentare