REQUIRED FOR INSTALLATION
• Drill with ³⁄₈" (10mm) dia. bit
• Slotted or phillips screwdriver
• Pliers / or adjustable end wrench
• Requires minimum 2" (50mm) clearance behind mounting panel
after installation.
APPLICATION
• Install switch in dashboards or panels up to 1" (25mm) thick.
• Rated load is 20 amps.
MOUNTING INSTRUCTIONS
1. Bring power source wire and switched wires to panel. Attach wires
to terminal screws. Figure 1
2. Remove chrome handle and chrome nut from shaft.
3. In desired location, drill ³⁄₈" (10mm) dia. hole through panel. From
inside panel, insert shaft through hole.
4. Tighten chrome nut and handle onto end of shaft. From inside,
tighten brass nut and washer against panel.
Figure 1
3
®
Attwood marine hardware, navigational lighting, bilge pumps, and other
marine accessories are specified more than any other brand by America’s
best-known boat manufacturers as original equipment. Look to Attwood
for quality replacement parts and marine accessories.
SAVE THESE INSTRUCTIONS
Form Number 69408 Rev. A 03-01
Three-Position Pull Switch
7594
Installation Instructions
© 2003 Attwood Corporation
1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.com
Chrome
Handle
Chrome
Nut
3/8"
(10mm) Dia.
Brass
Nut
Brass
Washer
Panel:
1" (25mm) Max
Terminal Screw
Post #1 (Head)
Post #1-(ON)
OFF
Basic Operation
Post #1-(ON)
1st Position:
Accessory #1
2nd Position:
Accessory #2
Post #2
(+)
(Bat.)
(+)
(-)
(+)(-)
(+)
(-)
12V Battery
Fuse
Switched Wire
Switched Wire
Power Source
Wire
Kommentare zu diesen Handbüchern